NERSCPowering Scientific Discovery Since 1974

Open Issues

Resolved: qstat -a does not show correct hours in elpsed time for running jobs

July 12, 2013 by Helen He | 0 Comments

Sympton:

After the Torque/Moab upgrade on 6/19, the elapsed run time display from "qstat -a" does not show correct values for hours field for running jobs.  The minutes and seconds numbers are correct.  A job uses less than one hour displays correct elapsed time such as 50:03, but once a job's running time is over 59 min, the hours field is always displayed as 0.

0 comments | Read the full post