NERSCPowering Scientific Discovery Since 1974

Resolved: qstat -a does not show correct hours in elpsed time for running jobs

July 12, 2013 by Helen He (0 Comments)

Sympton:

After the Torque/Moab upgrade on 6/19, the elapsed run time display from "qstat -a" does not show correct values for hours field for running jobs.  The minutes and seconds numbers are correct.  A job uses less than one hour displays correct elapsed time such as 50:03, but once a job's running time is over 59 min, the hours field is always displayed as 0.

Workaround:

For a running job, use "qs" command, to see the requested hours and correct elapsed time;  or use "showq" command, to see the requested houts and correct remaining hours;  or use "qstat -f" command to see the "start_time" and the correct "Walltime.Remaining" value in seconds.

Status:

This issue has been resolved with the batch software upgrade. 

 

 


Post your comment

You cannot post comments until you have logged in. Login Here.

Comments

No one has commented on this page yet.

RSS feed for comments on this page | RSS feed for all comments